20
CARAVAN LOADS
I think one of my loads is not receiving power?
The load may be faulty, activating the protective electronic fuse and turning the
load off. If this is the case, the LED Status Indicator on the J35 will flash a solid
red.
Should you encounter any faulty loads, please contact your caravan dealership.
None of my loads appear to be powered but I can still use my battery monitor?
All loads will power down, but the battery monitor will still be in use if the J35 was
put into Sleep Mode. The J35 will be put into Sleep Mode if:
1. The user pressed the Battery icon on their battery monitor.
Check to see that Battery icon on your monitor has been pressed, thus turning
power off to the caravan loads.
2. The J35 has entered Sleep Mode and to conserve remaining battery voltage
will disable power to caravan loads.
Connect the J35 to a power source and begin battery charging.
None of my loads appear to be powered and the screen on my battery monitor
has turned off?
All loads, including any battery monitor in use with the J35 will power down if the
J35 was put into Storage Mode. The J35 will be put into Storage Mode if:
1. The user activated the switch connected to the J35 Load Isolation input. This
turns off power to all caravan loads and accessories connected to the J35
CAN bus such as your battery monitor.
Check that the switch has not been activated.
2. The J35 has entered Storage Mode and to conserve remaining battery voltage
will disable power to all caravan loads and accessories connected to the J35
CAN bus.
Connect the J35 to a power source and begin battery charging.
To Next Page
Loading...
Need help?
General
