OZONE MONITOR BMT 932 Manual, Rev. 02/2021
50
Warning: This product relies on the building's installation for short-circuit (overcurrent) protec-
tion. Ensure that a fuse or circuit breaker no larger than 15 A at 120 VAC (10 A at 240 VAC) is
used on the phase conductor.
Warning: Disconnect electrical power before opening the cabinet door.
Précaution
: Couper l'alimentation avant d'ouvrier la porte d'analyseur.
Signal contacts (Connector "Output & Control") are as described on page 15. A splash-proof
connector for connection of the supplied serial cable is provided.
The BMT 932 C can be ordered with the option 932C-HAR. This provides a relay which can
switch an alarm horn in case of a High Concentration Alarm. Connection is made through an
additional splash-proof feed-through to the two pole connector on the PCB labeled "Horn". Ca-
ble diameter shall be 6.5 to 10 mm.
Warning: The equipment connected to the option 932C-HAR shall be fused at 4 A.
Précaution
: Assurer la protection de l’équipement connecté au option 932C-HAR avec une fusible pour 4A.
C4 Operation
The operation of the BMT 932 C is the same as of the standard BMT 932.
For further description of the functions and properties of the cabinet version please refer to the
main part of this manual.
To Next Page
Loading...