▷ "Charging in time slot": if a departure time
is set, a time window with a favourable
electricity tariff can be set for charging.
Charge in the time window
General
During the charging process, a time window with
a favourable electricity tariff can be set for charg‐
ing.
To set a time window for favourable charging, a
departure time must be set.
If the drive-ready state is switched off, changes
can be made using iDrive.
Setting the time window for favourable
charging
If a departure time is set, a time window with a
favourable electricity tariff can be set for charg‐
ing.
1.
"CAR"
2. "Plan charg./climate"
3. Tilt the Controller to the right.
4. "Settings"
5. "AC settings"
6. "Charging time slot"
7. Select the desired setting:
▷ "From:": set start of tariff.
▷ "Until:": set end of tariff.
The vehicle can also start the charging process
before the selected time window begins or end it
after the selected time window finishes. The
starting point of the charging process is adjusted
so the vehicle can be charged as much as possi‐
ble and, if applicable, be climate controlled right
up to the departure time.
If the drive-ready state is switched off, changes
can be made using iDrive.
The set time window can be ignored for the next
charging process: "Charge immediately once"
Stopping charging
Charging is interrupted when the vehicle is un‐
locked and automatically continued again after a
short time when it is locked.
The charging process can be terminated at any
time by removing the charging cable, and re‐
sumed at a later point by connecting the charg‐
ing cable. For example, so that other consumers
can use the power connection in the meantime
or to avoid high power output levels simultane‐
ously from a number of consumers.
For further information:
Removing, see page 359.
Resuming charging
If charging is interrupted, for example, by unlock‐
ing the vehicle or due to a temporary power fail‐
ure, charging is automatically continued after the
interruption.
Ending charging
1.
Remove charging cable from the vehicle.
Removing, see page 359.
2. Store charging cable if necessary.
3. Press on the charge point flap until it en‐
gages.
4. Lock vehicle as appropriate.
Displays in the instrument
cluster
When the standby state is switched on, the
charge state indicator shows the charge state of
the high-voltage battery in the instrument clus‐
ter. If all bars are filled in, the high-voltage battery
is completely charged.
Even if no bar is filled in, the high-voltage battery
is always under high voltage.
The charge screen displays information about
the charging process.
Seite 362
MOBILITY
Charging vehicle
362
Online Edition for Part no. 01405A1EA53 - X/20
To Next Page
Loading...
