Functional requirements
▷ The mobile phone must compatibly support
the required Qi standard. For compatible mo‐
bile phones, see Owner's Manual for the ve‐
hicle.
If the mobile phone does not support the Qi
standard, the mobile phone can be charged
using a special Qi-compatible charging case.
▷ The mobile phone must not exceed the maxi‐
mum size of approx. 5.9 x 2.9 x 0.6 in/151 x
74 x 16 mm.
▷ Only use protective cases and covers up to a
maximum thickness of 0.07 in/2 mm. Other‐
wise, the charging function may be impaired.
▷ Ignition or standby state is switched on.
▷ Storage tray: the mobile phone to be charged
is located in the center of the tray.
Storage in vertical position
General information
The wireless charging tray is located in the front
center armrest.
Overview
1 Bracket
2 LED
Inserting the mobile phone
1.
Open center armrest, refer to vehicle Own‐
er's Manual.
2. Slide the mobile phone with the display on
the side of the clamp into the tray.
3. Close the center armrest.
Removing the mobile phone
1.
Open the center armrest.
2. Remove the mobile phone.
Storage in horizontal position
General information
The wireless charging tray is located in the front
center armrest.
Overview
1 Front holder with LED
2 Storage area
3 Movable clamp
Inserting the mobile phone
1.
Open center armrest, refer to vehicle Own‐
er's Manual.
2. Push back the clamp.
Seite 87
Telephone
COMMUNICATION
87
Online Edition for Part no. 01402989211 - II/18
To Next Page
Loading...
