Not for Australia/New
Zealand: Recommended
child seats
Appropriate child restraint systems for every age
and weight class are available from a Service
Partner of the manufacturer or another qualified
Service Partner or a specialist workshop.
The manufacturer of the vehicle recommends
the following child restraint systems:
▷ BMW Baby Seat Group 0+.
▷ BMW Junior Seat Group 1.
▷ BMW Junior Seat Group 2/3.
▷ ISOFIX base.
▷ Römer KidFix XP.
For Australia/New Zealand:
Child restraints
General
In accordance with ADR 34/02, provisions have
been made to allow installation of a child restraint
at each rear seating position.
The anchoring hooks which belong to the upper
retraining strap of the child restraint - AS 1754,
can be applied immediately to the relevant
mounting.
Please refer strictly to the installation instructions
supplied with the child restraint system.
Each seating position is fitted with a head rest.
Safety notes
WARNING
Child restraint anchorages are designed to
withstand only those loads imposed by cor‐
rectly fitted child restraints. Under no circum‐
stances are they to be used for adult seat belts,
harnesses or for attaching other items or equip‐
ment to the vehicle. After using the child re‐
straints, fold the anchor fittings down again if
necessary.
WARNING
If the upper retaining strap is used incorrectly
with the child restraint system, the protective
effect may be reduced. There is a danger of in‐
jury. Make sure that the upper retaining strap is
not routed to the upper attachment strap over
sharp edges, and that it is not twisted.
Mounting points
The symbol shows the mounting point
for the upper retaining strap.
Depending on the equipment fitted in the vehi‐
cle, there are two outer mounting points or three
other mounting points for child restraints with
tether straps.
Seite 122
CONTROLS
Carrying children safely
122
Online Edition for Part no. 01402989787 - II/18
To Next Page
Loading...
