injury or even death. Have the airbag system
tested, repaired or removed and disposed of by
a Service Partner of the manufacturer or an‐
other qualified Service Partner or a specialist
workshop.
Display in the instrument cluster
When the drive-ready state is switched
on, the warning lamp in the instrument
cluster briefly illuminates in order to show
the operational readiness of the entire airbag
system and the belt tensioners.
Malfunction
▷ The warning lamp does not illuminate
after the drive-ready state is switched
on.
▷ The warning lamp is permanently illuminated.
Have the system checked.
Not for Australia/New Zealand:
Key switch for front passenger
airbags
Principle
When a child restraint system is used on the
front passenger seat, the front and side airbags
on the front passenger side can be deactivated
using the key switch for front passenger airbags.
General
The front and side airbags for the front passen‐
ger can be deactivated and reactivated using the
integrated key from the remote control.
Overview
The key switch for front passenger airbags is lo‐
cated on the outside of the dashboard.
Deactivating the front passenger
airbags
1.
Insert the key and press inwards where nec‐
essary.
2. While the key is pressed inwards, turn it to
the OFF position as far as it will go. Once the
stop position has been reached, remove the
key.
3. Make sure that the key switch is in the end
position so that the airbags are deactivated.
The front passenger airbags are deactivated.
The driver's airbags remain active.
If a child restraint system is no longer fitted in the
front passenger seat, reactivate the front passen‐
ger airbags so that they are triggered as intended
in the event of an accident.
The airbag status is displayed on the indicator
lamp on the roof lining, see page 174.
Seite 173
Safety
CONTROLS
173
Online Edition for Part no. 01402989787 - II/18
To Next Page
Loading...
