Reprogramming individual
buttons
1. Switch on standby state.
2. Press and hold the button on the rearview
mirror to be programmed.
3. As soon as the LED on the rearview mirror
flashes slowly orange, keep the hand-held
transmitter for the system to be operated ap‐
proximately 2 to 8 cm, 1 to 3 in away from the
buttons on the rearview mirror. The gap re‐
quired depends on the hand-held transmitter.
4. Also press and hold the button for the de‐
sired function on the hand-held transmitter.
5. As soon as the LED on the rearview mirror
flashes faster or illuminates, release both but‐
tons. The faster flashing or illumination shows
that the button on the rearview mirror has
been programmed. The system can then be
operated with the button on the rearview mir‐
ror.
If the LED does not start to flash faster after a
maximum of 60 seconds, change the dis‐
tance and repeat the programming from
step 4 onwards. Several attempts at various
distances may be necessary. Wait at least
15 seconds between attempts.
Operation
WARNING
Parts of the body can become trapped when
operating radio-controlled systems, for example
a garage door, with the integrated universal re‐
mote control. There is a danger of injury or
damage to property. When programming and
operating, make sure that the area of move‐
ment of the particular system is kept clear. Also
follow the safety notes supplied with the hand-
held transmitter.
The system, for example the garage door, can be
operated using the button on the rearview mirror
when the drive-ready state or standby state is
switched on. To do this, press and hold the but‐
ton within the reception range of the system, un‐
til the function is triggered. The LED on the rear‐
view mirror illuminates constantly when the radio
signal is being transmitted.
Deleting saved functions
Simultaneously press and hold the two outer
buttons on the rearview mirror for approximately.
10 seconds until the LED flashes rapidly green.
All saved functions are deleted. It is not possible
to clear functions individually.
Sun visor
Glare protection
Fold the sun visor downwards or upwards.
Glare protection from the side
Folding out
1.
Fold the sun visor downwards.
2. Remove the sun visor from the bracket and
pivot it sideways to the side window.
Folding up
To close the sun visor, follow the reverse se‐
quence.
Vanity mirror
A vanity mirror is situated in the sun visor behind
a cover. The mirror light switches on when the
cover is opened.
Seite 272
CONTROLS
Interior equipment
272
Online Edition for Part no. 01402989787 - II/18
To Next Page
Loading...
