▷ Press the button, arrow 1, on the inside of the
boot lid.
▷ Press the button, arrow 2.
The vehicle is locked after the boot lid has
been closed. To do this, the driver's door
must be closed and the remote control must
be outside the vehicle in the vicinity of the
boot lid.
Cancelling the closing operation
The closing procedure is interrupted in the
following situations:
▷ When driving off suddenly.
▷ By pressing the button on the outside of the
boot lid. Pressing the button again re-opens
the boot lid.
▷ By pressing the button on the inside of the
boot lid. Pressing the button again re-opens
the boot lid.
▷ By releasing the button on the remote con‐
trol. Pressing the button again and holding it
down resumes the closing operation.
▷ By releasing the button in the driver's door.
Pulling the button again and holding it in this
position resumes the closing operation.
Malfunction
In the event of an electrical fault, manually oper‐
ate the unlocked boot lid slowly, avoiding jerky
movements.
Boot lid emergency release
Pull the handle in the boot.
This will unlock the boot lid.
Soft Close Automatic
Safety note
WARNING
Parts of the body can become trapped when
the doors are operating. There is a danger of
injury. When opening and closing, make sure
that the area of movement of the doors is kept
clear.
Closing
To close, push the door gently.
The closing operation is then performed auto‐
matically.
Driver profiles
Principle
Individual settings for several drivers can be
saved in the driver profiles and called up again as
required.
Seite 89
Opening and closing
CONTROLS
89
Online Edition for Part no. 01402989787 - II/18
To Next Page
Loading...
