BMW X1 - Page 134

Additional information:
Antilock Braking System, refer to page 202.
Assisted Driving Mode
Warning light illuminates and acoustic
signal sounds: A system interruption is
imminent.
Warning light flashes: A lane boundary has
been crossed.
Additional information:
Assisted Driving Mode, refer to page 220.
Assisted Driving Mode: Hands are not on
steering wheel
Steering wheel icon illuminates yellow:
Hands are not grasping the steering
wheel. The system is still active.
Grab the steering wheel with your hands.
Additional information:
Assisted Driving Mode, refer to page 220.
Dynamic Stability Control
Warning light flashes: Dynamic Stabil-
ity Control is regulating the driving and
brake power. The vehicle is stabilized.
Reduce the vehicle speed and adjust your driv-
ing style to the road conditions.
Warning light illuminates: Dynamic Stability
Control has malfunctioned or is initializing.
Driving stabilization is restricted or has failed.
If the warning light illuminates continuously,
have the vehicle checked immediately by an
authorized service center or another qualified
service center or repair shop.
Additional information:
Dynamic Stability Control, refer to page 202.
Dynamic Stability Control deactivated or
enhanced driving dynamics activated
Dynamic Stability Control is deactivated
or enhanced driving dynamics is acti-
vated.
Additional information:
▷ Dynamic Stability Control, refer to
page 202.
▷ Setting for increased driving dynamics, re-
fer to page 203.
Flat tire monitor
Warning light illuminates: Flat tire or
tire pressure loss has been detected.
Reduce your speed and stop cau-
tiously. Avoid sudden braking and steering
maneuvers.
Additional information:
Flat tire monitor, refer to page 334.
Tire pressure monitor
Warning light illuminates: Flat tire or
tire pressure loss has been detected.
Follow the information in the Check
Control message.
Warning light flashes then illuminates continu-
ously: Flat tires or tire pressure losses cannot
be detected.
▷
Fault caused by systems or devices with
the same radio frequency: after leaving the
area of the interference, the system auto-
matically becomes active again.
▷ In the case of tires with special appro-
val: the tire pressure monitor was unable
to complete the reset. Reset the system
again.
▷ Wheel without wheel electronics installed:
Have it checked by an authorized service
Seite 134
CONTROLS
Displays
134
Online Edition for Part no. 01405A8A536 - VI/23