BMW X1 - Page 150

To reactivate the Automatic High Beam Assis-
tant, press the turn signal lever up, arrow 1.
Deactivating Automatic High Beam
Assistant
Press the indicator/high-beam stalk forward,
arrow 1, or pull the high-beam stalk backward
when the high beams are on, arrow 2.
When the Automatic High Beam Assistant is
deactivated via iDrive, the operation with the
turn signal lever is not possible.
Sensitivity of the Automatic High
Beam Assistant
General information
The sensitivity of the Automatic High Beam
Assistant can be adjusted.
Safety information
Warning
If adjustments have been made or the sen-
sitivity has been modified, oncoming traffic
may be momentarily blinded. There is a risk
of accident. If adjustments have been made
and the sensitivity has been modified, make
sure that oncoming traffic is not momentarily
blinded. Switch off the high beams manually
if required.
Functional requirements
The following functional requirements apply
when adjusting the sensitivity of the Automatic
High Beam Assistant:
▷ Adjustment is possible only while your vehi-
cle is stationary.
▷ Drive-ready state is switched on.
▷ The light is switched off.
Increasing sensitivity
To increase the sensitivity of the Automatic
High Beam Assistant, push the indicator/high-
beam stalk forward for approx. 10 seconds.
A Check Control message is displayed. The
system responds more sensitively.
Resetting the sensitivity
To reset the sensitivity of the Automatic High
Beam Assistant, push the indicator/high-beam
stalk forward again for approx. 10 seconds or
switch off drive-ready state.
The sensitivity of the Automatic High Beam
Assistant is reset to the factory settings.
System limits
The Automatic High Beam Assistant cannot
replace the driver's personal judgment of when
to use the high beams. Therefore, when ap-
propriate, turn off the high-beam headlights
manually.
Seite 150
CONTROLS
Light and view
150
Online Edition for Part no. 01405A8A536 - VI/23