BMW X1 - Page 238

Turning circle lines
The turning circle lines show the path with the
smallest possible turning circle on level roads
in the camera image on the control display.
Only one turning circle line is displayed after
the steering wheel is turned past a certain an-
gle.
Turning circle lines can only be superimposed
on the camera image together with pathway
lines.
Using parking aid lines
1.
Position the vehicle so that the red turning
circle line leads into the boundaries of the
parking space.
2. Turn the steering wheel so that the green
pathway line covers the corresponding
turning circle line.
Obstacle marking
The sensors detect obstacles when parking.
The obstacles detected by the Park Distance
Control are shown and marked in the camera
image on the control display.
Colored gradients for the obstacle markings in
green, yellow and red indicate the distances.
Functional limitations
The parking assistance systems can only be
used to a limited extent in the following situa-
tions:
▷ With a door open.
▷ With open cargo area.
▷ With exterior mirrors folded in.
Areas with gray hatching with an icon in the
camera image identify areas that are currently
not shown such as an open door.
System limits
Safety information
Warning
Due to its limits, the system may not react, or
it may react too late or in a manner that is not
consistent with normal use. There may be a
risk of accidents or risk of damage to prop-
erty. Actively intervene as warranted. Refer
to the information in this Owner’s Manual re-
garding the scope of the system’s operation
and limitations.
System limits of the sensors
Parking assistance systems may be restricted
by the system limits of the sensors.
Additional information:
Sensors of the vehicle, refer to page 34.
Field of view
Because of the camera angle, the areas under
the vehicle cannot be viewed by the cameras.
Seite 238
CONTROLS
Parking
238
Online Edition for Part no. 01405A8A536 - VI/23