9
Email •
support@boblov.com https://www.boblov.com/
BOBLOV
moving object detected, the device will stop recording in
10 seconds.
3. Pre-Record: If you enable Pre record function, it allows
you to record extra 15 seconds video before recording
start, while a blue flashing dot is displayed on the screen.
4. Post-Record: If you set Post Record to 5s / 30s / Imin
ute / 5minutes, the device will record extra 5s / 30s /
Iminute / 5minutes video after recording stop.
5. Record with sound: If you set Video Sound to OFF,the
device will record videos without sound.
6. Stealth Mode: If you set Stealth mode to ON, the device
will disable all sound and light of the device in video
recording, audio recording and photographing.
7. Dash Camera Mode: If you set Car Dash Cam Mode to
ON, the device will start recording automatically when
connected to an USB power supply.
6.5. Take Photos:
1. Single shot: In standby mode, short press"00 "Button
once, red light flashes once, and take one photo, photo files
are named after the date and time, saved in JPG format.
2. Multiple shots: If you set Photo Burst Mode to
3P/5P/10P/20P, when the device is powered on, short
press" 0/) "Button once, red light flashes once, and take
3/5/10/20 photos, photo files are named after the date and
time, saved in JPG format.
3. Snapshot: During video recording, short press" O
Button to take one photo, photo files are named after the
date and time, saved in JPGformat(Multiple shots is
available too)
9
To Next Page
Loading...
