If idle the camera for a ong time or take out the
card from the camera, all the settings will be
restored. Need to connect the camera to PC and
follow the above steps to set the correct time and
save
Note: After changes, need to power on the camera
once to read the change, otherwise it can't be
changed successfully. Please check whether the
time stamp is registered to the video file
successfully or not, after setting correct, the time
data in the " time" txt file will go back to the default
time due to the software design. It will not affect
your use. The camera will record along with the
modified time.
Main Function
4.1 Powering OnIOff & Standby
Long press@buttontopoweronthecamera,
working indicators appear. The working indicator
(i) is solid red, and working indicator (2)is solid
green. Long press@buttontopoweroffthe
camera. After powering on 5 minutes, if without
any operation, the camera will flash red and blue
indicators for seconds and auto shut off, ong press
@ the buttonto poweron camera
05
support@boblov.com
To Next Page
Loading...
