Home Checkup Test
If UltraVision is not performing as well as he should, you can diagnose the problem with a simple home
checkup test.
Putting UltraVision in/out of checkup mode
To put UltraVision in Checkup mode:
Press and hold the “GO” “CHARGE” and “WI-FI” buttons simultaneously for a few seconds until the
bot says: “Home Checkup Mode Activated”. In this mode, UltraVision’s LiDAR sensor rotates.
To exit the Checkup mode:
Press the “GO” “CHARGE” and “WI-FI” buttons together again. You’ll hear “Exiting Home Checkup
Mode” and UltraVision’s LiDAR sensor stops rotating.
Important Notes:
- During the test, if UltraVision’s left idle for over a minute, he’ll automatically exit the Home Checkup
Test.
- To move among Steps in the Checkup test, press the Wi-Fi button.
- To start / stop the tests in each Step, press the GO button until you hear “Begin Test” and “Stop
Test”. Always stop a test before moving to the next step.
Step Part(s) Tested Description
1 Battery After a full charge, test UltraVision’s battery.
2 Edge Sensors Test edge sensors individually.
3 Charging Station Test charging sensors individually.
4 Bumpers, Wi-Fi, and Camera Test the Wi-Fi module, touch sensors, and camera.
5
Motors (wheels, brushes, vacuum,
mop)
Test each of UltraVision’s motors
individually.
6
SLAM LiDAR, Charging and
Self-empty
Test UltraVision’s SLAM LiDAR, charging contact points,
and self-empty function.
7 Hard Resetting UltraVision Factory reset UltraVision and erase all data.
For a step-by-step video guide of Home Checkup Test, visit: bobsweep.com/UltraVision-support.
28
To Next Page
Loading...
