bObsweep UltraVision - Page 35

FAQs
UltraVision is not self-empty-
ing and the indicator on the
station is ashing red.
By default, every time UltraVision docks, a loud
vacuuming process empties his dustbin into his
station’s disposable dust bag. You can change the
frequency using the bObsweep App.
If UltraVision’s dustbin gets too packed, or if the
station’s air passage is clogged, contents cannot
be vacuumed out. Remove and open the dustbin
and dump its contents. Unplug the station and
open the air passage to remove anything clogging
it.
UltraVision won’t turn on no
matter what I do.
If UltraVision is not responding to his buttons, then
his battery has likely drained too low for him to
operate. Place UltraVision on his charging station
and allow him to fully charge. When placing
him on the station, ensure the dustbin is fully
latched, and there’s perfect alignment between
the charging nodes on the back of UltraVision
and his charging station’s.
UltraVision’s having trouble
nding his station.
Make sure UltraVision’s charging bed is installed.
You may need to relocate UltraVision’s station to
a more accessible area. Make sure the station
is placed in a centralized area, on a hard, at
surface away from stairs or edges, direct sunlight,
mirrors or reective surfaces, and with plenty of
open space around it. Then, erase the old map
and let UltraVision remap the house from his new
station.
UltraVision runs out of battery
before he’s nished mapping.
Use the ‘Swift Map’ feature on the bObsweep app
to ask UltraVision to map the oor without cleaning
it. In this mode, UltraVision explores and maps the
house, then returns to his charging station without
cleaning it. If the oor is too large for UltraVision to
fully clean in one charge, toggle on Auto-resume
under Settings > Cleaning Preferences on the
bObsweep app, and UltraVision will pickup where
he left off after recharging.
Can I pick UltraVision up?
Picking up and moving UltraVision during a cleaning
session is not recommended, as it can affect his
current cleaning cycle/map. Furthermore, it’s best
not to relocate UltraVision’s charging station once
he has mapped his environment. If you have to
relocate the station, erase the old map and let
UltraVision map the house again.
UltraVision’s not picking up as
much as he used to.
UltraVision will have trouble cleaning if his dustbin
is clogged, or his main brush is clogged or tangled
with hair. Remove UltraVision’s main brush and
clean it thoroughly from end to end. Remove and
open the dustbin, and remove any large debris
from UltraVision’s dustbin container to ensure
smooth ow of air.