Be careful to assemble all components
in the sequence they are presented.
A. Loosen Allen Head Bolts (63) at the bottom of Bench Press Frame (J).
Slide out Pivot Shaft (Y) from inside of Bench Press Frame (J).
B. Attach Bench Press Frame (J) to Main Base Frame (A) using the Pivot Shaft (Y) as shown.
Retighten Allen Head Bolts (63) at the bottom of Bench Press Frame (J).
C. Attach Convex End Caps (3) to the top of Vertical Support Pillar (D), front of Top Frame (F),
and to the bottom of Bench Press Frame (J) as shown.
mm
Inch
3
6
Note:
Wrench tighten all hardware in this
step only. Do not wrench tighten Frame
bolts until after the installation of the weight stack in step 6.
STEP
To Next Page
Loading...
