Body Solid G4I - STEP 9: Weight Stack Cable Routing; Weight Stack Cable Routing

9
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
18
STEP
A. Attach Weight Stack Cable (32) between Top Side Panels (G) using:
One 48 (3/8” x 3 3/4” hex head bolt)
Two 74 (3/8” washer)
Two 7 (spacer sleeve)
One 72 (3/8” nylon lock nut)
B. Route Cable (32) through the Double Pulley Holders (BB) and hold Pulley (A1) in place using:
One 52 (3/8” x 1 3/4” hex head bolt)
Two 74 (3/8” washer)
One 72 (3/8” nylon lock nut)
C. Route Cable (32) up and between Top Side Panels (G).
Route Cable (32) around Pulley (A2) and install Pulley (A2) between Top Side Panels (G) using:
One 48 (3/8” x 3 3/4” hex head bolt)
Two 74 (3/8” washer)
Two 5 (spacer sleeve)
One 72 (3/8” nylon lock nut)
D. Route Cable (32) through Single Pulley With Hook (BC) and around Pulley (A3).
Install Pulley (A3) using:
One 52 (3/8” x 1 3/4” hex head bolt)
Two 74 (3/8” washer)
One 72 (3/8” nylon lock nut)
Attach Rubber Pad (28) to the top of Single Pulley With Hook (BC) as shown.
Weight Stack Cable (32)
Stamped Eye End
Metal Ball End
2670mm 8’ 9”