Name: Boge C 30 N
Brand: Boge
Rating: 5 (1 reviews)

To Next Page

www.boge.com

Operating instructions

Belt-driven

screw compressors

Series

C 16 N...C 30 N

C 16 F N...C 30 F N

Separate manual:

compressor control

frequency converter (C F N)

Default Chapter1
- Operating Instructions1
- Table of Contents5
General Safety Instructions9
- Safety Instructions for Compressor Operation9
- Part 1: 1.1 General Safety Instructions9
- Special Hazard Warnings10
- Electrical Energy Hazards11
- Obligations of the Owner11
- Personnel Requirements11
- Personal Protective Equipment12
- Safety Instructions for Maintenance and Repair12
- Accident Prevention Regulations13
- Disposal13
Introduction13
- Symbols Used14
- Symbols on the Compressor14
- Intended Use18
- Foreseeable Misuse18
- Transport Damage18
- Data on the Type Plate19
- Service19
Technical Data - Compressor21
- Part 2: 2.1 Technical Data – Compressor21
Function Description Compressor25
- Function Principle of the Air End25
- Air Circuit25
- Oil Circuit26
Water Cooling27
- Series Connection27
Cooling Water27
- Water Connection (for Water Cooling)27
- Cooling Water Quality28
Compressor Control28
- Network Pressure28
- Operating States28
- Operating Modes29
- Control of Compressors with Frequency Control (C F N)29
- Short Operating Times29
Safety and Monitoring Devices30
- General30
- Safety Temperature Limiting Device30
- Safety Valve30
- Monitoring the Drive Motor30
3.1 Transport and Storage31
Part 3: Transport and Storage31
- General31
- Transport Possibilities31
- Part 3: 3.1 Transport and Storage31
- Intermediate Storage32
Compressor Room33
- Pressed Air Receivers: Receiver Mounted or Seperately Installed33
- Installation Surface33
- Fire Protection33
- Sound Protection34
- Admissible Environmental Influences34
- Ventilation34
- Cooling Air Requirement35
- Ventilation Possibilities36
- Condensate Disposal36
Installation37
- General37
- Checking the Delivery Scope37
- Installing the Compressor37
- Connection Condensate Drain38
- Connecting the Compressor to the Compressed Air Network38
- Remove Cladding38
- Activating the Belt Tensioning Device40
- Checking the Oil Level40
Electrical Connection40
Commissioning41
- Checking Installation Requirements42
- Checking the Rotational Direction42
- Checking Compressed Air Outlet for Tightness43
- Opening the Stop Valves43
- Checking for Leaks43
- Conducting Trial Run44
- Commissioning Following Extended Stoppages44
Dismantling45
BOGE-Duotherm BPT47
- Function47
- Assembly47
- Commissioning47
- Part 4: 4.1 BOGE-Duotherm BPT47
- Maintenance48
General49
Faults - Compressor49
- Part 5: 5.1 General49
Safety Instructions51
- Part 6: 6.1 Safety Instructions51
General53
- Maintenance through BOGE Customer Service53
- Review of Regular Maintenance Work53
- Maintenance Intervals54
- General Information Concerning the Lubricants Used56
- Disposal of Used Operating Material56
- Pressure Hoses56
- Spare and Wearing Parts57
Maintenance Work Compressor57
- Cleaning or Changing Suction Filter57
- Cleaning the Filter Cartridge58
- Changing the Supply Air Filter Mats58
- Drive Motors with Permanent Lubrication59
- Changing the V-Belt59
- Settings of the GM-Drive System C 16 N61
- C 16 F N61
- Checking the Oil Level, Topping up Oil62
- Changing the Oil Filter63
- Changing Oil Separators64
- Oil Change65
- Flushing the Oil Circuit67
- Cleaning the Compressed Air/Oil Cooling Unit67
- Function Check of the Safety Valve68
- Inline Filter69
Spare Parts and Optional Equipment70
- List of Spare and Wearing Parts of the Compressor (for Maintenance)70
- List of Available Optional Equipment70
Part 7: Flow Chart71
7.1 Flow Chart72
- Air Cooled Version, Standard, Series C 16 N72
- C 16 F N72
- Water Cooled Version, Serial Connection, Series C 16 N74
- C 20 F N74
- BOGE-Duotherm BPT Plate Heat Exchanger76
Appendix77
List of Maintenance and Service Work77

Brand	Boge
Model	C 30 N
Category	Air Compressor
Language	English

Boge C 30 N User Manual

Table of Contents

Questions and Answers:

Boge C 30 N Specifications

Related product manuals