Specifications
12
Power Output (RMS): V35: 35W (45W Typical, @ 1 kHz/0.1%/4Ω)
V60: 60W (85W Typical, @ 1 kHz/0.1%/4Ω)
V100: 100W (140W Typical, @ 1 kHz/0.1%/4Ω)
V150: 150W (200W Typical, @ 1 kHz/0.1%/4Ω)
V250: 250W (340W Typical, @ 1 kHz/0.1%/4Ω)
Frequency Response
Transformer: 45-20 kHz; 0/-2 dB @ FRP
Direct: 20-20 kHz; 0/-1 dB @ FRP
Distortion
Transformer: 0.5% THD+N, Maximum, Full-rated bandwidth @ FRP
Direct: 0.1% THD+N, Maximum, Full-rated bandwidth @ FRP
Direct: 0.05% THD+N, FRP @ 1 kHz
Signal-to-Noise
Fundamental: -94 dB*
With Aux Module: -70 dB*
With Mic Module: -60 dB*
With Tel Module: -70 dB*
Tone Controls
Bass Frequency: 100 Hz (+/- 10 dB minimum)
Treble Frequency: 10 kHz (+/- 10 dB minimum)
Low Cut Frequency: 125 Hz @ -6 dB/octave
Sensitivity 0.4V (at backplane connector)
Output Regulation: 2 dB or better no load to full load
Output Impedance
Transformer-Coupled: 70V, 25V, 8 ohms; balanced or unbalanced
Direct Coupled: 4 ohms
Inserts
Insert "OUT" Level: 1VRMS (@FRP)
Insert "OUT" Impedance: 50 ohms maximum
Insert "IN" Sensitivity: 1VRMS
Insert "IN" Impedance: 10k ohms minimum
Buffered Output
Output Level: 4VRMS (Max Amp Gain @ rated input sensitivity
Output Impedance: 50 ohms maximum
AC Power Receptacle: 500 watts maximum power, unswitched
AC Line Draw: V35: 0.6A;V60: 1.3A;V100: 2A;V150: 3.5A;V250: 5.5A
Dimensions: 16
1
/2" W x 3
1
/2" H x 12" D (all models)
Product Weight: V35: 24 lb.
V60: 28 lb.
V100: 32 lb.
V150: 35 lb.
V250: 40 lb.
* Referenced to FRP output level, 20-20 kHz bandwidth limited.
All specifications subject to change without notice.
To Next Page
Loading...
