8-10
Adding VoIP Speakers to Quantum List via Quantum Commander
7. Enter other required field information (e.g., Zones, Day/Night Admin, etc.) depending on station type.
8. Click Apply
(Figure 2-1).
9. Select Save from the File menu to save the configuration for the VoIP Speaker.
10. After saving, the VoIP Speaker will automatically reboot. Wait a couple of minutes for the VoIP Speaker to
finish rebooting.
11. Check the VoIP Speaker Locator
(Figure 1-7)
. The VoIP Speaker should now have an assigned Architecture
Number. Press Discover, then review the View Device Status tab.
NOTE: If you want to later change the volume of a VoIP Speaker that is currently playing Audio Distribution, the
speaker’s volume will not change until after the speaker: 1) receives an intercom call, 2) is reset, 3) receives a
page, or 4) program distribution is restarted.
NOTE: When VoIP Speakers are provisioned, the VoIP Speaker Primary Quantum IP Address setting must always
be set to the Primary Quantum Node’s IP Address. After that, the VoIP Speaker can be added to any Quantum
Node in the network, regardless of node type (e.g., Primary, Secondary or Normal).
✍
✍
To Next Page
Loading...
Need help?
General
