Bohmer-AG 5000K-E - Starting Procedures; Starting 2500 K; 3000 K; 3800 K; Starting 3800 K-E; 5000 K-E; 7000 K-E

K Series
© Böhmer-AG © Böhmer-AG
7
English
Starting 2500K / 3000K / 3800K
Starting 3800K-E / 5000K-E / 7000K-E
1. Turn the circuit breaker on and then connect your devices:
• AC: Connect device’s plug to 3-pin plug outlet
• DC: Connect your device’s black wire to the black negative terminal, the red wire to the red positive
terminal. This can be used to charge the battery (electric start models only).
• Turn the fuel tap to the on position.
2. Push the choke lever to the left (closed position).
3. Pull recoil handle until engine starts.
4. Once warm push choke lever to right (open position)
1. Turn the circuit breaker on and then connect your devices:
• AC: Connect device’s plug to 3-pin plug outlet
• DC: Connect your device’s black wire to the black negative terminal, the red wire to the red positive
terminal. This can be used to charge the battery (electric start models only).
• Turn the fuel tap to the ON position.
2. Push the choke lever to the left (closed position).
3. Turn the ignition key to the ON position
4. Once warm push choke lever to right (open position)
Fuel tap
ON
O
F
F
Choke lever Circuit breaker
OFF
ON
Recoil handle
Ignition key
OFF ON START