K Series
© Böhmer-AG © Böhmer-AG
9
English
1. Remove spark plug cap and unscrew the spark
plug using the supplied tool.
2. Carefully clean any carbon build-up on the tip.
3. Check the gap using a gauge. The gap should
be between
0.7-0.8mm
.
4. Adjust as necessary then reinstall the plug and
cap taking care not to cross-thread the spark
plug.
Maintenance
Spark plug
1. Unscrew the oil dipstick
2. Undo the oil drain plug and drain the oil
3. Install and tighten the oil drain plug
4. Add 10W-40 semi-synthetic oil to the upper
limit of the ller hole
5. Install dipstick
Oil dipstickOil drain plug
Filler hole
Oil change
To Next Page
Loading...
