Bomag BPR 25/32 - Changing the Engine Oil

0DLQWHQDQFHHYHU\PRQWKV
%20$* 35BPR 25/32 - BPR 25/40
Maintenance every 6 months
4.12 Changing the engine oil

Danger
Danger of scalding!
When draining hot engine oil.

Caution
Environmental damage!
Catch old oil and dispose of environmentally.
L
Note
Drain the engine oil only when the engine is warm.
Park the machine on level ground so that the en-
gine is in horizontal position.
Observe information concerning fuels and lubri-
cants.
Fig. 33
● Tilt the machine towards the steering handle.
● Support the machine safely.
● Unscrew the oil filler cap 1 (Fig. 33).
● Unscrew oil drain plug (2) and catch running
out old oil.
● Clean the drain plug and turn it in with a new
seal ring (3).
Fig. 34
● Adjust the engine horizontally.
● Fill in new engine oil through the filler opening
(Fig. 34).
For quality and quantity of oil refer to the table
of fuels and lubricants.
● Screw the oil filler plug in.
● Check the oil level again after running the en-
gine for approx. 1 minute.
● The oil level must reach up to the bottom edge
of the oil filler neck.
● If the oil is below this level top up oil immedi-
ately.
Go to Discount-Equipment.com to order your parts