BOMANN GSPE 892 - Page 13

13
Pr
PrPr
Pro
oo
ogram
gramgram
gram Program selection
Program selectionProgram selection
Program selection informat
informatinformat
informati
ii
ion
onon
on Program sequence
Program sequenceProgram sequence
Program sequence
Detergent
DetergentDetergent
Detergent
pre/main (g)
pre/main (g)pre/main (g)
pre/main (g)
Time
TimeTime
Time
(Min.)
(Min.)(Min.)
(Min.)
Ene
EneEne
Ener
rr
rgy
gygy
gy
(kWh)
(kWh)(kWh)
(kWh)
Water
WaterWater
Water
(l)
(l)(l)
(l)
90 Min.
for lightly soiled dishes
Main rinse (65°C)
Rinse
Rinse (65°C)
Drying
30
(or Tab)
90 1.35 12.5
Rapid
rapid rinse cycle for lightly
soiled dishes without drying
Main rinse (45°C)
Rinse
Rinse (55°C)
20 40 0.75 11.5
NOTE
NOTENOTE
NOTE:
::
:
*EN 50242: this program is the test program and of combined energy and water consumption most efficient.
The information for comparability:
Capacity: 12 settings; Position of the upper basket: lower position; rinse aid setting: 6
Control
ControlControl
Control panel
panelpanel
panel
1
11
1 Power: button to turn on/off the power supply.
2
22
2 Program: button to select the rinse program.
3
33
3 Delay: button to select the start delay of 3, 6,
or 9 hours. Close the door and the appliance
starts automatically after the selected time delay
has expired.
4
44
4 The control lamps indicate the program selection.
5
55
5 The control lamps indicate the start delay
selection.
6
66
6 Control lamp: lights up when rinse aid must be
added.
Control lamp: lights up, when dishwasher salt
needs refilling.
Starting a pr
Starting a prStarting a pr
Starting a program
ogramogram
ogram
• The water supply must be opened up to the max-
imum pressure.
• Load the dishwasher baskets.
• Fill in the detergent.
• Turn on the appliance.
• Set the required program options.
• Start the operation by closing the appliance door.
Changing the program
Changing the programChanging the program
Changing the program
CAUTIO
CAUTIOCAUTIO
CAUTION:
N:N:
N:
A program change should be done only a short time
after starting the program. Otherwise, maybe deter-
gent has been released and already drained rinse
water.
• To make a program change, carefully open the
appliance door so that you can operate the control
panel.
• Press the Program selection button for more than
3 seconds.
• Select a new program and close the appliance
door.
Forgot to add a dish?
Forgot to add a dish?Forgot to add a dish?
Forgot to add a dish?
WARNING:
WARNING:WARNING:
WARNING:
Open the door very carefully during operation, there
is a risk of water squirting out.
Dishware can be added any time before the deter-
gent dispenser opens.