Why is the indicator of speed saw band not functional on my Bomar Ergonomic 320.250 DGS?
If the indicator of speed saw band is not functional on your Bomar Saw, possible causes are: * The sensor of speed is not adjusted. Sensor of speed must be adjusted. * Defective display. The display must be changed. * Wrong sensor – diode of indicator speed is not light. Sensor must be changed and adjusted.
What causes the electric motor and pump to be without voltage on my Bomar Ergonomic 320.250 DGS Saw?
If the electric motor and pump are without voltage and there is no voltage between the contactor and thermal protector on your Bomar Saw, it could be due to: * A wrong contactor. Replace the contactor of the engine.
Why by choke is not possible turn on my Bomar Ergonomic 320.250 DGS Saw?
If you cannot turn the choke on your Bomar Saw, it may be due to: * Metal clamps between the valve and panel. Clamps must be removed and put on the shaft O-Ring about 10x2 mm. * Metal clams are in the body of valve. The valve must be cleared or changed.
Why is the cleansing of the saw band not functional on my Bomar Saw?
If the cleansing of the saw band is not functional on your Bomar Saw, check for: * A worn-down elastic wheel of the brush drive. The elastic wheel of the brush must be changed. * A worn-down knurling of the driving wheel. The driving wheel must be changed. * A rusted shaft of the brush drive. The shaft of the brush must be cleaned and oiled.
Provides instructions for operating the Ergonomic 320.250 DGS machine.
Contact details for BOMAR, including address, phone, fax, and email.
Covers machine determination, personal protective equipment, operator safety, and servicing precautions.
Details the location of machine identification labels and safety symbols.
Provides technical specifications, installation diagrams, and component descriptions.
Instructions for transportation, stocking, activation, unpacking, and initial setup.
Details electrical connections and cooling system filling procedures.
Procedures for checking machine functions and information on saw band selection.
Describes the main switch and control panel elements for machine operation.
Step-by-step guides for cutting, setting material length, and adjusting speed/angle.
Procedures for dismantling, installing, stretching, and inspecting the saw band.
Covers adjustments for various components, machine cleaning, and wear part replacement.
Guidelines for cooling agents, greases, oils, and disposal of chips.
Lists common mechanical issues, their causes, and repair procedures.
Identifies electrical faults and provides troubleshooting and repair solutions.
Includes various electrical wiring diagrams for different machine configurations.
Diagram illustrating the hydraulic system of the machine.
Assembly drawing for the Ergonomic 320.250 DGS model.
Assembly drawing and piece list for the saw arm.
Assembly drawing and piece list for the machine vice.
Assembly drawing and piece list for the control panel.
To Next Page
General
