Why is my BONFIGLIOLI 315 L DC Drives bearing temperature too high?
High bearing temperature in BONFIGLIOLI DC Drives can occur due to several reasons: * The oil level might be too low, in which case you should top up the oil level. * The oil might be spent, requiring replacement. * The bearings could be defective, in which case you should contact an authorized workshop.
What to do if my BONFIGLIOLI DC Drives gear unit does not run or runs with difficulty?
If your BONFIGLIOLI DC Drives gear unit isn't running smoothly, here's what could be happening: * The oil viscosity might be too high, requiring you to replace the oil, referring to the recommended lubricant chart. * The oil level might be too high, so you should check the oil level. * The load applied might be excessive, suggesting a redesign of the drive for the actual load required.
Why is my BONFIGLIOLI 315 L operating temperature too high?
High operating temperatures in BONFIGLIOLI DC Drives can be attributed to: * The oil level being too high, so you should check the oil level. * The oil being spent, meaning it needs to be replaced. * Contaminants in the oil, indicating the oil should be replaced.
What causes abnormal running noise in BONFIGLIOLI 315 L DC Drives?
Abnormal running noise in your BONFIGLIOLI DC Drives can stem from several issues: * Damaged gears, defective or worn bearings, or excessive bearing axial backlash, all require contacting an authorized workshop. * Excessive load applied, which can be corrected by adjusting the load to the rated values in the Sales Catalogue. * Contaminant in oil, which means you should replace the oil.
What causes oil leaks in BONFIGLIOLI 315 L?
Oil leaks in BONFIGLIOLI DC Drives can be caused by: * Oil level being too high, so you should check the oil level. * Inadequate casing/coupling seals or worn gaskets, both require contacting an authorized workshop.
What causes abnormal noise at gear unit mounting in BONFIGLIOLI 315 L DC Drives?
Abnormal noise at the gear unit mounting in BONFIGLIOLI DC Drives can occur if: * Mounting bolts are loose, so you should tighten bolts to the specified torque. * Mounting bolts are worn, so you should replace the bolts.
What to do if the output shaft does not turn with motor running in BONFIGLIOLI DC Drives?
If the output shaft of your BONFIGLIOLI DC Drives isn't turning while the motor is running, it could be due to damaged gears, which requires contacting an authorized workshop.
Details critical safety instructions, required qualifications, and general precautions for safe operation.
Explains safe lifting and handling operations for the gear unit using certified accessories.
General steps for installing the gear unit, ensuring safety and proper alignment.
Details the process for installing gear units with flanged connections, including machining and tolerances.
Describes mounting procedures for gear units with hollow splined shafts, including bolt specifications.
Instructions for mounting gear units using feet, including base requirements and bolt specifications.
Details mounting procedures using shrink disks and torque arms, including bolt specifications.
Precautions and procedures for installing an IEC 72-1 electric motor to form a gearmotor.
Details on connecting hydraulic motors, including O-ring gasket and flange mounting procedures.
General| Brand | BONFIGLIOLI |
|---|---|
| Model | 315 L |
| Category | DC Drives |
| Language | English |
To Next Page