4
1.3 - GLOSSARY AND TERMINOLOGY
Some of the frequently occurring terms used in this manual are described below to unequivocally define their
meaning.
Routine maintenance
The set of operations required to preserve the functionality and efficiency of the gear unit. These operations
are usually scheduled by the Manufacturer, who defines the qualifications and tasks involved.
Reactive maintenance
The set of operations required to preserve the functionality and efficiency of the gear unit. These operations
are not scheduled by the Manufacturer and must be carried out by an expert maintenance technician.
Expert maintenance technician
An authorised technician with the qualifications, skills and mechanical and electrical training required to do
repairs and non-routine maintenance work on the gear unit.
Overhaul
An overhaul consists in the replacement of bearings and other mechanical components which have worn to
such an extent as to compromise the operation of the gear unit. An overhaul also includes verification of the
condition of all gear unit components (keys, seals, gaskets, vents, etc). If any such components are dama-
ged they must be replaced and the reason for the damage identified.
1.4 - REQUESTING TECHNICAL ASSISTANCE
For any technical service needs, contact the Manufacturer’s sales network quoting the information indicated
on the unit’s nameplate, the approximate hours of service and the type of defect.
1.5 - MANUFACTURER’S LIABILITY
The Manufacturer declines all liability in the event of:
•
use of the gear unit in contravention of local safety at work legislation
•
incorrect installation, disregard or incorrect application of the instructions provided in this manual
•
incorrect or defective electrical/hydraulic power supply (gearmotors)
•
modifications or tampering
•
work done on the unit by unqualified or unsuitable persons.
The safety of the gear unit also depends on scrupulous observance of the instructions given in this manual,
and in particular:
•
always operate the unit within its operating limits
•
diligently observe the routine maintenance schedule
•
only allow trained operators to inspect and service the unit
•
only use original spare parts
•
the configurations given in the gear unit catalogue are the only ones permitted
•
do not attempt to use the unit in any other way
•
the instructions given in this manual do not substitute but rather supplement the provisions of esta-
blished safety legislation.
1.6 - CONSIGNMENT CONDITIONS
Gear units are supplied by BONFIGLIOLI TRASMITAL in the following conditions:
•
Configured for installation in the mounting position specified in the purchase order.
•
Not charged with lubricant and with internal components protected by a film of oil compatible with the
recommended lubricant.
•
All surfaces and mating parts are treated with rustproofing products.
•
Mating surfaces are not painted while the unit’s exterior is treated with a coat of grey water-based
rustproofing primer (RAL 7042/C441). Application of a top coat is the responsibility of the Client.
•
Tested to factory standards.
•
Packaged suitably for the final destination.
To Next Page
Loading...
Need help?
General
