4 / 32
IOM BX-BE-BN-MX-ME-M_eng - Translation of original instructions in Italian - Rev 02_0 - 30/09/16
3.4 Storage
Observe the following instructions to ensure correct storage of products:
a) Do not store outdoors, in areas exposed to weather or with excessive humidity.
b) Always place boards in wood or other material between oor and products, to avoid direct contact
with the oor.
c) For storage periods exceeding 60 days, all coupling surfaces such as anges and shafts must be
protected with a suitable anti-oxidation product (Mobilarma 248 or equivalent).
d) For storage periods exceeding 6 months, it is a good rule to turn the rotor every 1-2 months and to
take adequate measures against corrosion and humidity.
3.5 Motor installation
Check that mains assembly and service conditions comply with the information on the plate
and described in the technical documentation.
The following instructions must be observed when installing the motor:
Prior to installing the motor remove from the shaft the plastic guards that are supplied for transporta-
tion purposes.
These must be disposed of according to the rules applicable in the Country where the installation
takes place.
If applicable, remove oxidation preventative coating of shaft by means of a suitable solvent, which
afterwards must be disposed of according to the regulations applying locally.
Do not let the solvent be in touch with oilseal lips.
Motors may be handled individually by lifting them with belts or chains (if required due to weight).
Motors of frame sizes BX 100 / MX3, BE 100 / ME3, BN 100 / M3, and larger, are provided with an
eyebolt / lifting point for lifting purposes.
The eyebolts / lifting points are suitable for lifting the motor only.
Make sure that the motor rests in a stable manner and will not roll (in the case of anged motors).
To Next Page
Loading...
Need help?
General
