1.2: PREPARING THE WOODEN POLES
If you are assembling the stretch tent using aluminium poles, you can skip this step.
Each pole to which corner or side clamps are attached must be pre-drilled. To do this, use a 16 mm
drill bit and drill a 7 cm deep hole as centrally as possible.
Note: For tents with a width of 10 m or more (+ 10 m) we recommend the use of carabiners (see
step 1.2.1.). This way, the fabric gets more space to move and the risk of damage to the fabric with
windy weather is reduced.
» Remove the hand clamp from the side clamps.
» Use the oblong nut in the hand clamp to re-tighten the side clamps. You can use the hand clamp
and the supplied hexagonal wrench to tighten the nut. The hand clamp is not used in the side
clamps if you are using wooden poles.
7
To Next Page
Loading...