3B-490033NU – 10/19 Page 6
BONNET GRANDE CUISINE
Rue des Frères Lumière - Z.I Mitry Compans
77292 MITRY MORY Cedex
"END" finishes the cycle.
24.2 MANUAL CLEANING AT THE END OF SERVICE (or between 2 different types of cooking)
- Start the appliance.
- Wait a few seconds for the welcome screen to clear.
- Check that the drain outlet is closed
- Fill the tank with a few centimetres of water
- Add as required a degreasing agent (after cooking
with oil…) or a descaler (after cooking using water …)
- Heat the water to around 55°C to activate the product
- Clean the base using a spatula suitable for high temperatures or a special stainless scourer. Clean the cooktop regularly as it is
important to avoid repeated incrustation of dirt
Activate the water feed
Open the drain outlet
S
top the water feed
Tilt the well into the drain position
- Finish the rinse with the spray hose
- Dry with paper towel
Note: It is strongly advisable to dry the base of the tank. Stagnant water mixed with cleaning products or chlorine, even diluted, can in the long term,
cause irreversible corrosion to the tank base
24.3 RAPID CLEANING OF TANK
- Start the appliance.
- Wait a few seconds for the welcome screen to clear.
- Check that the drain outlet is closed
Activate the water feed
Open the drain outlet
- Clean the base using a spatula suitable for high t
emperatures or a special stainless scourer. Clean the cooktop regularly as it is
important to avoid repeated incrustation of dirt
To Next Page
Loading...