BonsenKitchen CM8009 - Frothing Milk;Producing Steam to Heat Liquids

Remove the removable tank and fill it with desired water, the water level should not exceed
the “MAX” mark in the tank. Then insert the tank into the appliance properly.
Then connect the appliance to power supply.
Press down the ON/OFF button “ ” to turn on the unit, the power indicator (red)
illuminates.
Press down the pump control button “ ” to the lower position, make sure the coffee/steam
button “ ” is at the higher position, the pump will pump water, when there is water flowing
out, close the pump immediately.
Press down the coffee/steam button “ ” to the lower position and wait for a moment, the
appliance begins to heat until the (green) lamp illuminates, it means the heating is finished.
Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the steam wand
about 2 centimeters into the milk. Turn the steam knob in anti-clockwise slowly to start
making steam.
Then the desired result is got, you can turn the steam knob to the “O” position.
Please follow the operation as below to avoid the steam outlet being blocked after finish
frothing milk each time: put an empty jug under the steam band, then turn on the steam knob
and press down the pump control button “ ” to the lower position, the pump will pump
water, after the water flowing out for 30 seconds, press the pump control button “ ” to the
higher position, finally, clean the steam outlet with wet sponge, but care not to be burnt!
Press and release the ON/OFF button “ ” to cut off the power source.
Note: Please follow the operation as below if the steam outlet is blocked: firstly turn the
steam knob to “O” position and make the coffee maker cool down for about half an hour,
8
FROTHING MILK/PRODUCING STEAM
TO HEAT LIQUIDS
The steam wand can be used to froth milk and make hot beverages like drinking chocolate,
water or tea.
Method:
you want to make coffee immediately, follow the next steps: First, press and release the steam
button “ ” to the higher position; dip the steam wand into a cup; secondly, press the pump
control button “ ” down to the lower position and turn on the steam control knob and there will
be water flow out from steam wand ; after the ready indicator extinguish, press and release the
pump control button “ ” to the higher position, then turn the steam control knob to “ ”
position. When the ready indicator illuminate, you can start to brew coffee again.