MAKE ESPRESSO COFFEE
Remove the funnel by turning it clockwise.
Add ground coffee to steel mesh with measuring spoon, a spoon ground coffee power
can make about a cup of top-grade coffee, then press the ground coffee powder tightly
with the tamper.
Set steel mesh into metal funnel (no coffee in steel mesh), then put the metal funnel
under the metal funnel holder (see Fig.1), and turn it anticlockwise until it is fixed
tightly (see Fig.2 and Fig.3).
Pour out the hot water in the cup. Then place the hot cup (yourself cup) on removable
cup shelf.
Make sure the steam knob is at the "O" position and the coffee/steam button “” is at
the higher position.
At the time, the coffee indicator (green) is illuminated, once the lamp illuminates, you
should press down the pump control button“” to the lower position, wait for a moment,
there will be coffee flowing out.
You should press and release the pump control button “”to the higher position manual-
ly when desired coffee is obtained or the color of coffee changes weak obviously.
After finishing making coffee, press the ON/OFF button “”, and the power indicator and
coffee indicator go out and the coffee maker stops working, your coffee is ready now.
WARNING: do not leave the coffee maker unattended during making coffee, as you
need operate manually sometimes!
Note: During brewing coffee or making steam, it is normal that the ready indicator is
likely to extinguish, it only means that the heater is heating up to keep the temperature
at the standard range.
6
Press the ON/OFF button “ ” to turn on the unit, the power indicator (red) will
illuminate, make sure the coffee/steam button “ ” is at the higher position.
Press down the pump control button “ ” to the lower position, when there is water
flowing out, close the pump immediately by pressing the pump control button “ ”
again to the higher position. The purpose of the step is to pump the water of the tank
into the housing.
When the coffee indicator (green) is illuminated, and you should press down the pump
control button “ ” again, there will be hot water flowing out.
After water has flown for 20S, press the pump control button “ ” . The preheating is
finished.
To Next Page
Loading...
