EasyManua.ls Logo

BonsenKitchen CM8009 - Preheating

BonsenKitchen CM8009
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
To make a cup of good hot Espresso coffee, it is recommended to preheat the
appliance before making coffee, including the funnel and cup, so that the coffee
flavour will not be influenced by the cold parts.
PREHEATING
Remove the removable water tank and fill it with desired water, the water level should
be between the “MAX” mark and the “MIN” mark in the tank. Then insert the tank into
the appliance properly.
Set steel mesh into metal funnel (no coffee in steel mesh), then put the metal funnel
under the metal funnel holder (see Fig.1), and turn it anticlockwise until it is fixed tightly
(see Fig.2 and Fig.3).
Place an espresso cup you have prepared on removable cup shelf.
Then connect the appliance into power supply. Make sure the steam knob is at the "O"
position.
5
Place an espresso cup you have prepared on drip plate. Make sure the steam knob is
at the “O” position.
Note: As the appliance is not equipped with any cup or jug, prepare your own jug or
cup.
Connect into power source, press down the ON/OFF button “ ” to turn on the unit.
The power indicator (red) will be illuminated.
Press down the pump control button“ ”, the pump will pump water, when there is
water flowing out and close the pump by pressing the pump control button“ ” again.
Note: When you Press down the pump control button“ ” to the lower position, The
pump indicator yellowwill turn on ,when you press and release the pump control
button“ ”to the higher positionThe pump indicator will turn off .
Make sure the coffee/steam button“ ” is at the higher position and wait for a
moment, the appliance begin preheating until the steam/coffee indicator (green)
illuminates, it means that the preheating is finished.
Press down the pump control button“ ” again, and water will flow out.
After water has flown for 1 minute, press the pump control button “ ”, you can pour
out the water in each container then clean them thoroughly, now you can start brewing
coffee.
Note: There may be noise when pumping the water for the first time, it is normal, as
the appliance is releasing the air in the appliance. After about 20s, the noise will
disappear.

Related product manuals