bora XBO - Functions and Operation; Switching the appliance on and off; Opening;closing the door

Functions and operation
EN
74 bora.com
5 Functions and operation
u Observe all safety and warning information
(see"2Safety").
5.1 Switching the appliance
on and off
The sensor button reacts to finger contact. You
switch the appliance on and off with this button.
u Long press on .
T When turned off, the appliance is temporarily
switched to sleep mode and after 15 minutes the
software is completely shut down.
5.2 Opening/closing the
door
Opening the door
u Tap
T The door opens slightly.
u Use both hands to open the door as far as it will go.
If you do not do this within 10 seconds of the
door opening, it will close again automatically.
Closing the door
When the door is fully open:
u use both hands to tilt the door upwards until the
automatic function closes the door.
When the door has been pre-opened:
u Use both hands to open the door as far as it will go.
u use both hands to tilt the door upwards until the
automatic function closes the door.
do not push the door closed when pre-opened;
this may damage the appliance.
5.3 Operating the touch
display
The touch display reacts to finger contact. It recognises
different touch commands:
Touch command Contact Time (contact)
Touch Brief touch 0.5s
Long press Longer contact 1–8 s
Swipe Vertical/horizontal
Swiping movement
0.1–8 s
Number scroll
wheel
Vertical swiping movement using the
number scroll wheel until the desired
value appears in the middle of the
scroll wheel.
Tab.5.1
Touch commands
u Only touch the display with your fingers.
u Make sure that your fingers are clean and dry before
using the touch controls.
u Ensure that no other parts of your hand are touching
the display when using the controls.
u Keep the contact area as small as possible when
using the touch zones.
Activating a function, selecting a button or
menu item
u Touch the symbol.
5.4 Information and
instructions
The menu item “First steps” contains helpful
videos on how to operate and handle the XBO
steam oven.
Information and tips
The programmes provide practical information and tips:
u Touch i in the presets
u Touch the “info” button under “Special programmes”
u Touch the “Pro tip” button under “Automatic
programmes”
Instructions
When you press the “Instructions” button, an animation
will explain how to do certain things (e.g. inserting the
BORA cleaning cartridge).
Status messages
Status messages are shown on the top edge of the display.
u Please take note of status messages.