40
• Make sure that the pump’s electrical connections are made in accordance with the information
provided by the pump manufactuer.
• Make sure cut-off valves on the water installation are in the open position.
• Bring the pump online.
7.13.2 Maintenance
It is recommended that maintenance procedures be carried out every month. These maintenance
procedures are important since they affect the unit’s capacity for humidification.
7.14 STEAM HUMIDIFIER SYSTEM
All provisions stated under the heading of 2. GENERAL SAFETY must be applied during the
commissioning and maintenance of the steam humidifier system.
7.14.1 Initial Start-up
• Make sure that connections of steam hoses to the diffuser are correct and tight.
• If ready steam is used in the system, bring the steam valves in the open position and ensure
steam flow.
• If the system uses a packaged steam generating device, make sure its electrical connections have
been made. Bring the unit online in accordance with the manufacturer firm’s user manual.
7.14.2 Maintenance
It is recommended that maintenance procedures be carried out every month. These maintenance
procedures are important since they affect the unit’s capacity for humidification.
WARNING: FİX THE SCREW BEFORE COMMİSSİONİNG!
Periodical Maintenance on the High Pressure Humidifier System:
• Check whether the high pressure humidifier section conform to hygiene standards, and check
for accumulated dust, corrosion, and damages.
• Clean inside the drain pan.
• If slippery surfaces can be detected by hand on the section surface, the section interior must
be cleaned and disinfected.
• The pipe lines must be checked for leaks, and any leaks must be promptly eliminated.
• The circulation pump must be checked against mechanical friction.
To Next Page