44
CHECK AGAIN
Air Handling Unit Does
Not Operate
• Make sure there is power in the supply line.
• Make sure the main switch on the panel of the unit is on.
Insufficient Heating and
Cooling Performance
• Check the level of dirtiness of the filters and the inner
equipment.
• Check whether the flow rate of cold and hot water suppliers are
suited for the design specifications of the project.
• Check if there is any air leakages that can be detected by hand.
9 COMMISSIONING REQUEST FORM
The fields that have been provided in the following form must be completed in full in order for the unit
to be commissioned. Otherwise it will not be possible to commission and adjust the unit.
BOREAS AIR HANDLING UNIT COMMISSIONING REQUEST FORM
Dear Sir or Madam,
Please send us the following form after properly fill out the fields below.
Date of Filling:
Make and Model of the Unit:
Number of Units:
Name and Address of the Facility in which the Unit is Installed:
1- Is the Unit installed on a base?
2- Are there enough space around the unit for
servicing as indicated in the Installation,
Commissioning and Maintenance Manual?
3- Have ductwork connections been performed
as indicated in the Installation, Commissioning
4- Have the electrical connections been
installed as indicated in the Installation,
Commissioning and Maintenance Manual?
To Next Page