BorMann BCD4010 - NOISE INFORMATION; VIBRATION INFORMATION; ASSEMBLY AND OPERATION INSTRUCTIONS; Before Operation

WWW.NIKOLAOUTOOLS.GR
EN
ASSEMBLY AND OPERATION INSTRUCTIONS
Before operaon
• Insert the baery (4) into the designated spot below the handle (1) unl it clicks into place.
• To remove the baery, press the baery unlocking latch (A) and slide the baery out of the handle.
Inserng/removing the baery (Fig. A)
• Remove the baery (see secon "Inserng / removing the baery").
• Connect the power adapter (14) to the charging port (B) of the baery.
• Connect the plug of the charger to a suitable socket.
- During the charging process, the red charging indicator glows.
- Aer about 60 - 90 minutes, the red indicator light goes out.
- The green indicator light glows connuously when the charging is completed.
Note: The charger will become warm and may make slight buzzing sounds while charging. This is normal and does not indicate a fault.
• Disconnect the charger's plug from the socket once the baery is fully charged.
Charging the baery (Fig. B)
Warning: Do not use the product in potenally explosive atmospheres. Use the product only in ambient temperatures between 10 - 40°C.
Turn o the machine before carrying out any maintenance or repair work or mounng or replacing accessories.
Cauon: The baery is slightly charged when it leaves the factory. Charge the baery fully before using it for the rst me.
The baery heats up while charging. Always allow the baery to cool down to room temperature before you charge the baery.
Checking the baery level (Fig. C)
• To check the charging status, the baery level indicator lights up when you press the control buon (C).
• The baery level is shown by 3 LEDs.
- 3 LEDs start glowing: Baery is charged.
- 2 LEDs start glowing: Baery is parally charged.
- 1 LED starts glowing: Baery needs to be charged.
Mounng the safety guard (Fig. D)
• Mount the safety guard (9) on the product unl it clicks into place and screw it on to the side using the screw provided on the safety guard.
NOISE INFORMATION
A-weighted sound pressure L
pA
= 78.5 dB(A)
A-weighted sound power L
wA
= 90.76 dB(A)
Guaranteed sound level 96 dB(A)
Uncertainty K
pA
&K
wA
3 dB(A)
Warning: Wear hearing protecon.
VIBRATION INFORMATION
Vibraon emission value a
h
for main handle 3.28m/s
2
Vibraon emission value a
h
for addional handle 3.96m/s
2
Uncertainty K 1.5m/s
2
Warning: This power tool may cause hand-arm vibraon syndrome if used frequently for extended periods of me without taking breaks
regularly and if protecve gloves are not worn.
Warning: The vibraon emission values can dier from the aforemenoned ones depending on how the power tool is used, the materials
being cut and if:
• The tool is not in good condion and not well maintained.
• Accessories are used that do not match the tool.
• An-vibraon accessories are not used.
• The tool is not used as intended.
Noise emission values determined according to EN 50636.
EN
WWW.NIKOLAOUTOOLS.GR
7