-21-
6.4 NO output mode
The LCD of the UPS display in “No output mode” is shown in the
following diagram. The information about the mains power, the battery,
the UPS output and the load is displayed. The “0” code indicates the
UPS is working in the “No output” mode.
6.5 EPO (Emergency Power Off)
It is also called RPO (Remote Power Off). On the LCD display, the
mode code is “0”, the word “EPO” is presented in the position of
output voltage.
It is a special status in which the UPS would switch the output off and
alarm. The UPS cannot be turned off by pressing the “OFF” button on
the panel until the EPO has been released by turning or releasing the
EPO switch.
■
■■
■
No output mode
To Next Page
Loading...
Need help?
General