English | 9
Bosch Power Tools 1 609 92A 0B7 | (25.7.13)
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
Products sold in AUS and NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
While reading the operating instructions, unfold the graphics
page for the machine and leave it open.
Intended Use
The machine is intended for cutting, roughing and brushing of
metal and stone materials without the use of water.
For cutting with bonded abrasives, a special cutting guard
(accessory) must be used.
When cutting in stone, provide for sufficient dust extraction.
With approved sanding tools, the machine can be used for
sanding with sanding discs.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Spindle lock button
2 On/Off switch
3 Auxiliary handle (insulated gripping surface)
4 Grinder spindle
5 Mounting flange with O-ring
6 Grinding wheel*
7 Clamping nut
8 Two-pin spanner for clamping nut*
9 Quick-clamping nut *
10 Carbide grinding head*
11 Cutting disc*
12 Hand guard*
13 Spacer discs*
14 Rubber sanding plate*
15 Sanding sheet*
16 Round nut*
17 Cup brush*
18 Cutting guide with dust extraction protection guard *
19 Diamond cutting disc*
20 Handle (insulated gripping surface)
21 Protection guard for grinding (clamping screw)
22 Locking screw for protection guard
23 Protection guard for cutting (clamping screw)*
24 Protection guard for for grinding cup*
25 Grinding cup*
26 Two-pin spanner, offset, for grinding cup*
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Angle Grinder GWS ... 22-180
H
22-230
H
22-230
JH
24-180
H
Article number 3 601 ... H81 1.. H82 1.. H82 2.. H83 1..
Rated power input
W22002200 2200 2400
Output power
W15001500 1500 1600
Rated speed
min
-1
8500 6500 6500 8500
Grinding disc diameter, max.
mm 180 230 230 180
Thread of grinder spindle
M 14 M 14 M 14 M 14
Thread length (max.) of grinder spindle
mm 25 25 25 25
Reduced starting current
– – –
Rotatable main handle
– –––
Weight according to EPTA-Procedure 01/2003
– with vibration-damping auxiliary handle
– with standard-auxiliary handle
kg
kg
5.1
5.0
5.1
5.0
5.3
5.2
5.0
4.9
Protection class
/II /II /II /II
OBJ_BUCH-827-006.book Page 9 Thursday, July 25, 2013 3:44 PM
Ташев-Галвинг ООД
www.tashev-galving.com
To Next Page
Loading...
