To Next PageTo Next Page
Need help?Do you have a question about the Bosch 4000 and is the answer not in the manual?
General| Type | Table Saw |
|---|---|
| Motor | 15 Amp |
| Voltage | 120V |
| Blade Diameter | 10 inches |
| Arbor Size | 5/8 inches |
| Max. Rip Capacity Right | 30 in |
| Max. Depth of Cut at 90 Degrees | 3-1/8 inches |
| Max. Depth of Cut at 45 Degrees | 2-1/4 inches |
| No-Load Speed | 3, 650 RPM |
| Dust Port Size | 2-1/2 in |
Safety preamble before operating the tool.
Contact and support information for the consumer.
Guidelines for safe workspace and operator well-being.
Proper methods and limitations for using the power tool.
Maintaining the tool and avoiding dangerous kickback incidents.
Recommendations for safety gear like goggles and gloves.
Emphasis on operator awareness and common sense for safety.
Description of the power switch and its safety functions.
Overview of the table, base, and their supporting features.
Description of rip fence and miter gauge functionality.
Operation and adjustment of blade guard and table insert.
How to use and adjust the miter gauge for angled cuts.
List of all components included with the table saw.
Procedure for adjusting the blade's tilt angle.
How to set precise 90 and 45 degree blade stops.
Aligning the blade parallel to the miter gauge slots for accurate cuts.
Adjusting the table extension and pointer for proper measurements.
Steps to ensure the rip fence is parallel to the saw blade.
How to adjust the miter gauge for accurate crosscuts.
Step-by-step guide for attaching the blade guard assembly.
Procedure for safely replacing the saw blade.
Instructions for attaching the rip fence to the table.
How to securely mount the table saw to a workbench.
Explanation of the safety power switch and its function.
Introduction to auxiliary devices for performing cuts.
Routine procedures for keeping the table saw in good working order.
Common causes and solutions for a saw that won't power on.
Troubleshooting steps for a blade not reaching operating speed.
Diagnosing and fixing excessive vibrations during operation.
