Bosch 4100DG-09 - Page 34

86
Boschtools.com
Toll Free: 877-BOSCH-99
• TPI: Teeth per inch:
The lower the TPI, the faster the blade will cut. The higher
the TPI, the cleaner the blade will cut.
• Tilt angle:
The tilt angle is the angle at which the blade cuts into the material.
A higher tilt degree produces a faster, more aggressive cut. Tilt
angle is optimized based on application for best life to speed ratio.
• Gullet:
The space between each tooth that collects and clears out the
material being cut. The deeper the gullet, the more efciently the
chips are cleared.
• Blade shapes:
Taper blade bodies are designed for plunge cutting, curve cuts and
easier starts in tough to reach applications. Non-taper bodies offer
more stability and straighter cuts.
• Settings:
Blade tooth settings vary from one blade to another to optimize
cutting efciency by material applications.
• Body thickness:
Thinner blades offer faster cutting and exibility for ush cutting.
Thick kerfs offer straighter and more stable cutting.
• Reinforced tooth:
A wide tooth base with a smaller gullet results in a stronger
tooth design.
TECHNICAL BLADE ANATOMY
Tip
Tilt angle
TPI
14 141818
Tooth
Geometry
2X2
®
2x2 Tooth Design
• Two alternating tooth pitch:
Increases cutting speed in
metal up to 20%
• Reinforced teeth:
Up to 50% longer life
against leading 18TPI
competitor blades.
1" blade height and thicker body (.042)
for straight cuts with less vibration
2x2 tooth geometry® (14+18 TPI)
cuts 20% faster in metal on average
than leading 18TPI competitor blades
• 14+18 2x2 tooth geometry covers multiple
material thicknesses with one blade.
5
º
tilt angle for faster
cuts and skid free starts
2x2 Tooth Design:
Two alternating tooth pitch:
• Increases cutting speed in
metal up to 20%
Combo teeth/reinforced teeth
followed by aggressive tooth:
• Increase life by 2X in metal
• Combine speed and durability
1" blade height and thicker body (.042)
for straight cuts with less vibration
2x2 tooth geometry® (8+10 TPI)
cuts 20% faster in metal on average against
leading competitor blades
• 8+10 TPI 2x2 tooth geometry covers multiple
material thicknesses with one blade
5
º
tilt angle for
faster cuts and
skid free starts
Clean for Heavy Metal
Speed for Heavy Metal
Tooth
Geometry
2X2
®
Bigger pitch,
bigger gullet
followed by a reinforced
tooth to clear material
(speed of cut)
Standard tooth
Smaller pitch,
smaller gullet
followed by an aggressive
tooth to clear material
(speed of cut)
Reinforced
tooth
Non-taper
Taper back
Gullet
Reinforced tooth
Reciprocating Saw Blades