Bosch 8-115 - Page 9

English | 9
Bosch Power Tools 1 619 P13 237 | (17.3.15)
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
Products sold in AUS and NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
Intended Use
The machine is intended for cutting, roughing and brushing of
metal and stone materials without the use of water.
For cutting with bonded abrasives, a special cutting guard
(accessory) must be used.
When cutting in stone, provide for sufficient dust extraction.
With approved sanding tools, the machine can be used for
sanding with sanding discs.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Release lever for protection guard
2 Spindle lock button
3 Thumbwheel for speed preselection
(GWS 11-125 CIE/GWS 14-125 CIE)
4 On/Off switch
5 Auxiliary handle (insulated gripping surface)
6 Grinder spindle
7 Extraction hood for sanding*
8 Mounting flange with O-ring
9 Carbide grinding head*
10 Clamping nut
11 Quick-clamping nut *
12 Protection guard for grinding
13 Grinding wheel*
14 Protection guard for cutting*
15 Cutting disc*
16 Hand guard*
17 Rubber sanding plate*
18 Sanding sheet*
19 Round nut*
20 Cup brush*
21 Cutting guide with dust extraction protection guard *
22 Diamond cutting disc*
23 Handle (insulated gripping surface)
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Angle Grinder GWS ... 8-115 8-125 10-125 11-125 CI 11-125 CIE
Article number
3 601 ... H20 ... H27 ... H21 ... H22 ... H23 ...
Rated power input
W 800 800 1000 1100 1100
Output power
W 500 500 630 660 660
Rated speed
min
-1
11000 11000 11000 11000 11000
Speed control adjustment
min
-1
– ––– 2800 – 11000
Grinding disc diameter, max.
mm 115 125 125 125 125
Thread of grinder spindle
M 14 M 14 M 14 M 14 M 14
Thread length (max.) of grinder spindle
mm 22 22 22 22 22
Kickback stop
– ––
Restarting Protection
– ––
Reduced starting current
– ––
Constant electronic control
– ––
Speed preselection
– ––– 
Weight according to EPTA-Procedure
01/2003
– with vibration-damping auxiliary handle
– with standard-auxiliary handle
kg
kg
1.9
1.8
1.9
1.8
2.1
2.0
2.0
1.9
2.0
1.9
Protection class
/II /II /II /II /II
OBJ_BUCH-348-008.book Page 9 Tuesday, March 17, 2015 9:13 AM