English – 6
u NAVIGATION SERVICES ARE PROVIDED FOR PLAN-
NING PURPOSES ONLY. INFORMATION FROM
NAVIGATION SERVICES MAY DIFFER FROM AC-
TUAL CONDITIONS. USER MUST EXERCISE INDE-
PENDENT JUDGEMENT WHEN USING THE NAVIGA-
TION SERVICES TO ENSURE THAT THE ROUTE
PROVIDED BY THE NAVIGATION SERVICES IS SAFE
AND APPROPRIATE FOR EBIKE USAGE.
Safety Instructions for Charging the On-
Board Computer Battery
u Only charge the on-board computer with USB
power source (5V, 1500mA max) and USB ca-
ble rated at least 1500mA. Using USB power
source or USB cable not appropriately rated for the
application may result in fire, explosion or personal
injury.
u Charge the on-board computer in temperatures
above +32degreesF (0degreesC) and below
+104degreesF (40degreesC). Store on-board
computer in locations where temperatures will
not exceed 104degreesF (40degreesC). This is
important to prevent serious damage to the battery
in the on-board computer.
u Do not expose on-board computer to fire or ex-
cessive temperature. Exposure to fire or tempera-
ture above 212 °F (100 °C) may cause explosion.
u Do not recharge the on-board computer (via
USB port) in damp or wet environment. Water
entering on-board computer may result in electric
shock or fire.
u Never submerge on-board computer in fluid of
any kind or allow fluid to enter them. Corrosive
or conductive fluid (such as seawater or industrial
chemical or bleach containing products, etc.) can
cause short circuit which may result in fire, per-
sonal injury and property damage.
u Battery leakage may occur under extreme usage
or temperature conditions. Avoid contact with
skin and eyes. The battery liquid is caustic and
could cause chemical burns to tissues. If liquid
comes in contact with skin, wash quickly with soap
and water. If the liquid contacts your eyes, immedi-
ately flush eyes with water for a minimum of
15minutes and seek medical attention.
u Place on-board computer on flat nonflammable
surfaces and away from flammable materials
when recharging on-board computer using ex-
ternal USB power source. Carpeting and other
heat insulating surfaces block proper air circulation
which may cause overheating of the on-board com-
puter. If smoke or melting of the on-board com-
puter is observed, unplug the external USB power
source immediately and do not use the on-board
computer. Contact customer service immediately.
u Before each use, check the on-board computer,
cable and plug. If damage is detected, do not use
the on-board computer. Damaged on-board com-
puter, charging cables and plugs increase the risk
of a fire, explosion and personal injury.
u Do not disassemble on-board computer. No user
serviceable part inside. Incorrect reassembly or
damage may result in fire or explosion.
u Read and observe the safety warnings and in-
structions in all operating instructions of the
eBike system and your eBike.
NOTICE: This device complies with part 15 of the
FCC Rules. Operation is subject to the following two
conditions:
1. This device must not cause harmful interference,
and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
NOTICE: Changes or modifications made to this
equipment not expressly approved by the Robert
Bosch GmbH may void the FCC authorization to oper-
ate this equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pur-
suant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against
harmful interference in a residential installation. This
1 270 U20 BN2 | (14.03.2023) Bosch eBike Systems
To Next Page
Loading...
Need help?
General
