Bosch B24CB80ESS - Water Dispenser; Ice Maker

en-us Water system
14
Changing the water filter or replacing it with a
bypass cap
1. Reach into the recess below the filter cover, pull it for-
ward slightly and remove it.
2. Turn the water filter counterclockwise by 90° and re-
move it ⁠.
‒ Remove the water filter with care as it is under pres-
sure.
Note:When removing it, a small amount of water may
drip out of the water filter. Remove the drips of water
with a dry cloth.
Tip:You can dispose of the old water filter with your
household garbage.
3. Insert the new water filter or the bypass cap all the way
into the filter opening and turn it 90° clockwise all the
way.
4. Slide the filter cover over the water filter all the way
back.
5. Discard the ice cubes produced during the first
24hours, and dispense water for 5minutes and dis-
card.
13.2 Water dispenser
Dispense filtered water via the water dispenser.
Dispensing water
▶ Press and hold the glass against the dispensing button.
‒ If water has not been dispensed for 48hours, the wa-
ter may have a "stale" taste.
‒ Flush the water system if water has not been drawn
for 5days. To flush the water system, dispense
68floz (2liters) of water.
13.3 Ice maker
Use the ice maker to produce ice cubes.
WARNING
Rotating parts may cause injury.
▶ Never reach into or underneath the ice maker.
Note:The ice cube maker automatically detects that the
ice storage container is full and stops producing ice cubes.
It may take up to 48hours until the ice storage container is
full.