Bosch B24CB80ESS - Troubleshooting

Troubleshooting en-us
19
Issue Cause and troubleshooting
Condensation accumulates on the
surface of the appliance and on
the shelves inside.
The water contained in warm and humid air condenses on the colder surfaces of the
appliance.
1. Wipe away the water with a soft, dry cloth.
2. Open the appliance as briefly as possible.
3. Ensure that the appliance is always closed properly.
A large volume of condensation
collects regularly in the fruit and
vegetable container.
Depending on the food and quantity stored, condensation may form in the fruit and
vegetable container.
1.
Remove the fruit and vegetable container. → Page16
2. Remove the ventilation clips and rotate them before inserting again ⁠.
Water output is reduced. Low water pressure.
▶ Check the pressure of the water supply system or the external water filter sys-
tem, e.g. reverse osmosis system.
Connect the appliance only to a water connection with sufficient water pressure.
The water filter is blocked.
▶ Change the water filter.
Water is dripping from the water
dispenser.
Air is in the water system.
▶ Keep dispensing water until it contains no more air.
The water dispenser is not func-
tioning.
There is no water being supplied to the appliance.
▶ Ensure that there is a water supply and that the shut-off valve on the water con-
nection is open.
Contact an installer if necessary.
Kink in the water hose.
▶ Turn off the water supply and straighten the kink in water hose.
If necessary, replace the water hose.
Ice cube production is low. The appliance has only recently been connected.
▶ Wait approximately 4 hours until the first batch of ice cubes is ready.
The freezer compartment has been opened frequently or for an extended period of
time.
▶ Check ice cube production after a few hours.
Low water pressure.
▶ Check the pressure of the water supply system or the external water filter sys-
tem, e.g. reverse osmosis system.
Connect the appliance only to a water connection with sufficient water pressure.
The water filter is blocked.
▶ Change the water filter.
Food or objects are blocking the fill level sensor for the ice maker.
▶ Remove all food and objects from the ice storage container.
Fault in the ice maker.
1.
Switch off the appliance. → Page10
2. Disconnect the appliance from the power supply.
Unplug the power plug or switch off the circuit breaker in the fuse box.
3. Reconnect the appliance after 5 minutes.
4.
If the fault persists, call customer service. → Page21
The ice maker is not functioning. Ice cube production is switched off.
▶ Switch on ice cube production.
There is no water being supplied to the appliance.