Bosch B8512G User Manual

206
en | Options Control Panels
2019.06 | 07 | F.01U.307.371 Bosch Security Systems B.V.
32.4 Cross points
Points can be assigned to cross point groups. When a point in a cross
point group detects an alarm, the control panel starts the cross point
timer. If a second point in the same cross point group detects an alarm
while the cross point timer is active, the control panel sends alarm
reports for both points.
If a single cross point detects an alarm and stays in alarm throughout
the cross point timer, the control panel sends an alarm report only for
that point. If a single point in a cross point group detects an alarm and
restores while the timer is still active, the system sends an unverified
event for that point. A second alarm on the first point does not create
an alarm event, but rather an unverified event.
Cross points are:
enabled on my system.
disabled on my system.

Bosch B8512G Specifications

General

Model	B8512G
Category	Control Panel
Power Supply	12 VDC
Series	G Series
Areas	8
PGM Outputs on Board	8
On-board Ethernet	Yes
Wireless Support	Yes
Manufacturer	Bosch
Input Voltage	16.5 VAC
Users	500
Communication Formats	IP, GSM, PSTN
Compatibility	Compatible with Bosch detectors, keypads, and communication modules