36
Thermostat Overview
Humidifier & Dehumidifier Operating Mode
You can enable automatic humidity control if the correct humidifier
or dehumidifier accessory was correctly wired and configured
during the thermostat’s initial setup. Based on the setup, the
thermostat turns on the humidifier during heating operation and
the dehumidifier will be turned on during cooling operation. You
can also configure the thermostat to operate similar to a
humidistat, which runs the humidifier or dehumidifier, regardless of
an active heating/cooling call.
Note: You may only operate in either humidifier OR dehumidifier
mode and may not operate in both modes at the same time.
Run Time
The thermostat keeps track of your run time for the Heating,
Cooling, Air Filter and Water Pad. You can also set a reminder for
Air Filter and Water Pad according to the number of calendar days.
When it reaches its predefined run time, the thermostat displays a
notification and sends a message to the registered smart
device(s).
Temperature, Alerts, and Auto-On
Alert: Send an alert message or turn on the system
automatically when the room temperature is out of the range
between set-points.
Note: Alerts are an additional source of protection for your
heating/cooling appliance.
To Next Page
Loading...
