Installation instructions
28
¡ Cut-out work on the units should be carried
out before installing the appliance. Remove
any shavings. Otherwise, the correct opera-
tion of electrical components may be ad-
versely affected.
¡ Only a licensed professional may connect
appliances without plugs. Damage caused
by incorrect connection is not covered un-
der the warranty.
Parts that are accessible during installation
may have sharp edges and may lead to cut-
ting injuries.
▶ Wear protective gloves
It is dangerous to use an extended power
cord and non-approved adapters.
▶ Do not use extension cables or multiple
socket strips.
▶ If the power cord is too short, contact cus-
tomer service.
This appliance is only intended to be fully fitted in a kit-
chen. It is not intended to be used as a tabletop appli-
ance or within a cupboard.
The fitted cabinet must not have a back panel behind
the appliance. The minimum installation height is
850mm.
Ventilation slots and intake openings must not be
covered.
In order to safely connect the appliance to the elec-
trical system, follow these instructions.
The appliance contains permanent magnets. These
may affect electronic implants, e.g. heart pacemakers
or insulin pumps.
▶ Persons with electronic implants must stay at least
10cm away from the appliance.
The use of multi-plugs, multiple connectors or exten-
sion cables may cause a fire.
▶ Never use multi-plugs, multiple connectors or exten-
sion cables.
¡ The appliance is fitted with a plug and must only be
connected to a protective contact socket which has
been correctly installed.
¡ The fuse protection must correspond to the power
rating specified on the appliance's rating plate and
to local regulations.
¡ A socket must only be installed by a qualified elec-
trician, and in accordance with the appropriate regu-
lations.
¡ If the plug is no longer accessible following installa-
tion, an all-pole isolating switch with a contact dis-
tance of at least 3mm must be present.
Observe the installation dimensions and the safety
clearances in a tall unit.
Do not fit the appliance too high up; it must be pos-
sible for accessories to be removed easily.
Remove the feet.
Observe the installation dimensions and the safety
clearances in a tall unit.
Do not fit the appliance too high up; it must be pos-
sible for accessories to be removed easily.
To Next Page
Loading...
