1 689 989 034 2008-08-11| Robert Bosch GmbH
16 | BEA 810 / BEA 840 EURO | Operationen
Maintenance6.
Cleaning6.1
Only clean the trolley, housing and LCD display with soft
cloths and neutral cleansing agents. Do not use any abrasive
cleansing agents or rough workshop cleaning cloths.
Calibration6.2
When used in areas subject to calibration, it is essential
that calibration is carried out regularly. Take note of
country-specific regulations for this.
Maintenance and maintenance intervals6.3
Routine maintenance maintains the readiness to i
operate.
The measurement equipment must be maintained un-
der the conditions stated in the operating instructions
within the periods specified therein. Maintenance can
be carried out by a maintenance service company, or by
competent personnel of the owner of the measurement
equipment; it must be proven and made clear on the
measurement device.
Devices which must be opened (repairs), must subse-
quently be re-calibrated. Device repairs (open device,
adjust, repair, etc.) may only be carried out by the au-
thorized customer service.
Information on maintenance is to be found in the docu-
ment 1 689 979 832 (BEA 050) included in the delivery
specification.
Spare parts and parts subject to wear6.4
Description Order Number
TFT monitor
1 687 023 482
PC
1 687 023 480
Mains connection cable
<)
1 684 461 106
USB mouse
1 687 022 915
PDR 371
1 687 023 435
BEA 050
1 687 022 934
RTM 430
1 687 022 599
USB connection cable (1 m) to re-
mote control receiver or printer
1 684 465 491
Remote control
Batteries (4 units)
<)
1 687 246 019
0 092 444 003
<)
Part subject to wear
Operation5.
Switching on/off BEA 5.1
Switch on or off with the central mains switch on the
back of the device (see Fig. 2; Item 5).
Before switching off the device, you must shut down i
the PC using the Windows operating system. Before
switching the device back on again, the PC should
have been switched off for at least 1 minute.
When operating the BEA, faults can occur, if a PC or i
other components (e.g. mouse, connecting cables)
are used, which have not been supplied by Bosch.
Operation5.2
The program operation of the “emissions system analy-
sis” can be found in the program description contained
in the supplementary equipment set.
Software update5.3
The software update of the “emissions system analysis”
can be found in the program description contained in
the supplementary equipment set.
Notes on faults5.4
Notes on faults in the ESA software can be found in the
program description.
To Next Page
Loading...
