64
|
Bosch Climate 5000 Series Ductless Air Conditioner / Heat Pump Outdoor Unit Service Manual
04.2020 | Bosch Thermotechnology Corp.Data subject to change
8.19 High pressure switch open (J5)
Error Code J5
Malfunction decision conditions If the sampling voltage is not 5V, the LED displays a failure code.
Supposed causes
f Wiring mistake
f Overload protector faulty
f System block
f Outdoor PCB faulty
Table 42
Troubleshooting:
Figure 62
Are the high pressure
switch and main control
board wired correctly?
n
f
f
Method:
Disconnect the plug.
Measure the resistance of
the
high pressure protector, if
the protector is normal the
value is 0, Does a problem
still exist?
Yes
Yes
Connect high pressure
switch and main control
board
No
Replace high pressure protector
No
t
Is the high
pressure protector
broken?
Is the outdoor ambient
temperature is higher than
50ć"
No
Stop the unit Yes
Check if the outdoor unit
ventilation is good
Yes
t
f
r
Ensure that the outdoor unit
ventilation is functioning properly
r
Is the heat exchanger dirty?
No
C
Clean the heat exchanger
Yes
Vacuum the system and weigh-in
refrigerant as per the system
requirement
Replace outdoor main
PCB. Is the problem
resolved?
High pressure protection enabled
?
Is the outdoor fan running
properly?
please refer to the solution of [fan
speed has been out of control
malfunction] . Find out the cause and
have it solved.
No
Yes
NO
Yes